conurus

luposf · Joined: 17 Aug 2006 Posts: 21 Location: Italy

Me and another member of this forum are affected by same problem: we are not amble to do the micro-adjust feature on 5D mark1

After going through steps 1-7, we don't get any blinking of the "ONE SHOT" or "AI SERVO" indicator.

Step 8 says, "Set the desired adjustment value according to the following table...". OK, how, physically, do you set the value? Nothing is immediately obvious on the camera.

conurus · Posted: Thu Jan 14, 2010 7:12 am Post subject:

Hi,

At step 7, "if the previously stored value is zero, or there is no previous value set, the MF indicator of the camera will not blink". Fresh off the factory, the stored value is in fact zero, and you would not get any blinking.

For 17-35, 24-85, 28-80, 70-200 and 100/2.8 use the first table in the instructions. For example if you want to set the adjustment to -8, according to the instructions the camera is set to f/16 and the lens to f/22. Press DoF preview.

luposf · Joined: 17 Aug 2006 Posts: 21 Location: Italy

Ok, now is clear.
I am going to try.